Setting the lora module channels. |
Configuring a new channel on the LoRa Modules
Step One Using an RS485-USB adapter, connect a 2 core cable between the adapter and the lora module as shown in the diagram below
Step Two Plug the RS485-USB Adapter into a laptop or computer and ensure that the RS485 Adpater can be seen with an Open COM Port.
Step Three Using a Pin or small screwdriver, press in and hold the Deploy Button on the Front of the Lora Module until the Green LED on the front starts to flash
Step Four Open up the LoRa software and configure the following settings:
|
Posted by: Adam Reynolds - March 4, 2021. This article has been viewed 9659 times. |
Online URL: https://kb.givenergy.cloud/article.php?id=48 |
Powered by PHPKB (Knowledge Base Software)